Since its founding, Böhm has been involved in the development of testers and measuring equipment. This has laid the foundation for the company’s expertise in the field of quality. The testers we supply are designed to optimize the quality and precision of manufacturing processes. Our advanced testing solutions enable comprehensive product analysis and inspection, ensuring the highest standards of quality and reliability.
They verify the functionality and safety of products, thereby eliminating the possibility that a defective product could leave the production line.
Identifying errors before shipment reduces the risk of complaints and increases customer satisfaction.
Testers ensure that products meet the required standards and specifications.
It detects faults, protects equipment, and ensures smooth operation.
Leak detection protects equipment, reduces risks, and prevents operational losses.
It identifies overloads, optimizes processes, and improves operational safety.
It ensures precise movements, fast cycles, and consistent repeatability in production.
We also use camera systems to measure the dimensions of parts.
Communication with electronic systems using CAN, SENT, and other protocols.
The final inspection that ensures top-notch quality.
We also specialize in the design and manufacture of EoL (End-of-Line) testers according to customer test specifications. These testers combine testing of mechanical, electrical, and other properties, such as leak tightness or surface quality captured by a camera. They are used to verify product quality at the end of the production line, where they test product functionality and safety. They ensure that products meet all norms and standards before being shipped to customers.
With over 25 years of experience, we specialize in the manufacture of calibration equipment that excels in precision and reliability. The purpose of calibration is to perform a reference measurement using an external measuring device and then correct the parameters in the controller.
Our devices support linearization, parameterization, and range adjustment for travel, angle, and other variables. Data transfer between the calibration system and the device being calibrated usually takes place via a bus, typically CAN or SENT. Calibration is often followed by an EOL test, which verifies the functionality and quality of products at the end of the manufacturing process.
We are here for you! Our teams are ready to help you with any questions you may have.
We handle the entire process, from initial design and engineering to final installation and commissioning at your facility. We take full responsibility for integrating the entire system so that you can start production immediately.
We respond flexibly to your specific requirements and sudden changes in the project. Thanks to our dynamic team and effective management, we can quickly adapt the technical specifications of the lines to precisely meet your current needs.
We design and manufacture automated machines, which we thoroughly test and then commission directly at your facility. No matter where you’re located, we’ll handle the installation and ensure a smooth start-up of your new production line right at your site.
Our partnership doesn’t end with installation. We provide fast technical support, regular maintenance, and rapid delivery of replacement parts. We are your reliable partner, ensuring that your production lines never come to a standstill.